Posted by ScottyHOMEy on August 09, 2008 at 19:02:50 from (71.241.215.129):
In Reply to: Farmall IHC B posted by maestro on August 09, 2008 at 16:45:03:
Valves as a rule can only blow back through the carb or the exhaust. A REALLLLLY bad head gasket could blow by if it failed JUST right, but that would be rare and a lucky break. Most likely she'll need rings at the least on one cylinder or more.
Try a compression test. Test each cylinder. Ideally, the range from the cylinder with the highest compression to the lowest wont be a variance of more than 10%. If so, sozzle a couple of teas[poons into any cylinder that showl low, and see if it comes up. If it does, that will confirm that rings are the problem on that cylinder.
We had a discussion yesterday on here. Depending on which head and pitons you have, 80ish would be good compresion. 60ish you can live with. Any lower you're gonna need work. Soner or later is your choice.
If you've got good compression on all but one cylinder, you have the option of working on just that one, but it will wind up stronger than the others. There's also the problem, should you find the sleeve out of round, for instance, that you'll need a new sleeve and piston set. That CAN be a problem doing only one, especially if it's an original, as the newer pistons tend to have different rod offsets to the crank and have to be done in sets of four. and then, of course, there's always the argument of, as long as you've got the motor out, why not do all four, have the crank turned and give the old girl a new set of bearings and seals. No better time ...
That said, if you do have to open the motor up, the best case is that you will find all the sleeves to be within tolerance for being in round, in which case, you can have the ridges at the top reamed, hone them up and put in new rings to fit, which (to me, anyway) would be a pretty satisfying job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.