I am in the process of moving and I had to move 2 gunsafes. One is 450 lbs and the other is 900 lbs (empty) ....Yep not so easy to move! I made up some short 1/2 inch pipes and used them as rollers...very slick. The forks of the tractor just reach in the front door to do the actual heavy lifting...Thank goodness! The lighter of the 2 is a Treadlock and the other is a Browning.I like them both, but the Browning is far better. I have around 100 guns and if they were to be stolen, no amount of insurance could replace them, thus I figure instead of paying for the insurance , I would use that same money and invest in a couple of good safes...not sorry I did! There is/was a company in East Hampton, Conn. (nesci industries)that made some really cool safes. One was a coffee table in the center of the room...pull a latch and the top would hinge up to reveal a metal safe built in, opened by a key. another was a grandfathers clock with a false front and electric movements. This also opened to reveal a vertical lockable safe. The 3rd that I remember was a living room end table that had a little lazy susan of sorts that when unlatched exposed the safe(handgun sized) and the top drawer pulled 2/3rds of the way out , although it seemed that is was fully open. By reaching a small latch on the underside of the drawer it fully opened, showing that it had a false back , leaving enough room for a single handgun. My dad always wanted to cut the back side of a cold water tank out to store guns. He figured no thief would be messing with an old water tank...probably would not even have to lock it. 3 dogs in the house help too.... Cal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
