Posted by kyplowboy on September 05, 2008 at 21:53:25 from (63.146.226.90):
In Reply to: ELECTRIC FENCE GROUND posted by shortorder on September 05, 2008 at 19:55:19:
Every one gets tired of me saying this, and I swear I don't sell'm but a Gallagher smart fix will save any one hours of head scratch'n and miles of walking. If I loose mine when I get home in the morning I will have another one by dinner on Monday!
Around here you need more than 4' of CLEAN metal to get a good ground. I have been told that the galvanized post that the county/state road crews leave at the end of every back road make good'ns. If you drive 3 of them, 10'+ apart down to where there is only a foot or two out of the ground and bolt your wire too'm it don't get two dry for'm to not work. So I have been told.
If it's only got 2k volts, sounds like he has a short some where if it's a good charger with a GOOD ground. Did he happen to say how many amps he is loose'n? He just needs to start take'n jump wires off till he isolates the problem if it can't be seen/herd from walking the line. I would start with the closest conection to the charger and see what it will put out. If he has a tester that told him he had 2k, take both wires off the box and see what he gets testing the hot stud to the ground stud, just an idea, some boxes will not put out much over 2kv these days.
Just as a point of refrence, my cows have never gotten out at any point over 1.5k. Calves start going under single strand of barb wire some where between .8 and 1.3. I try to keep normal fence at 3 or over. Bull/wean'n pen is 5 wire HT and stays 7K or better, ain't lost a bawler to his momma on the other side yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
