Posted by jdemaris on September 26, 2008 at 06:43:22 from (67.142.130.36):
In Reply to: Re: Not really . . . posted by Joe(TX) on September 26, 2008 at 05:43:24:
There is no such thing as a standard "closed center" pump. There are many variations. Any pump can be closed center if there is a way to shut it off when a function is not being used.
Piston pumps in general cannot feed themselves with oil, i.e. no suction. Even hydrostatic pumps use extra charge pumps.
In regard to the pump you are talking about? Kind of hard to comment since you don't give any specifics.
All John Deere closed-center piston pumps require addtional charge pumps to keep them supplied with oil - they cannot draw oil on their own. Same goes for many Massey Ferguson systems.
Again, as to your tractors? I have no idea what you have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
