Posted by kyplowboy on October 08, 2008 at 18:17:48 from (63.146.226.90):
In Reply to: fence post spacing posted by rick165 on October 08, 2008 at 11:36:15:
For HT hot wires I use T-post and space'n depends on the ground and what it's used for. For the wean'n pin and working pin (turn off juice when use'n working pin!!) I space post about ever 16' to 20'. On perimeter fence I space'm about 40' to 50' on flat ground. On hills and ridges I place them close enough to keep the bottom wire off the ground and the rest 8" to 12" apart. On some real rough ground I have post 5' apart to get over mounds or down in draws.
What you have to keep in mind is that with HT, the line post just have to hold the wires up and apart. The corner post, braces, and tighteners hold the tension. The spring action of the HT and the volts do the work. One of the advantages of HT is cost, alot of the savings come from not having to put a post every 16'.
One word of advice, and this is just my opinion, shop around and be sure to get 175k psi wire and not 200k. If you want to see if you can find some people to give you 10' of each and try to tie each to an insulator and splice each and see for your self before you drop $100 for a bundle of wire you won't like. Also becarefull when shop'n for insulators. Be sure what ever you buy won't break down in sunlight. I have had some cheap ones ger britle and break after 3 years. Also for line post insulators I like the pin lock ones.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
