Posted by KF on October 10, 2008 at 10:41:27 from (67.37.213.65):
In Reply to: Re: Installing glass posted by circus on October 10, 2008 at 04:08:22:
You are describing what has been done on the auto assembly line for years. It's called "roping in the glass". As described soap the rubber seal and place a small cord in the groove that is formed by the interior flap. Have both ends of the cord at the bottom with the rest looped around the top. Have someone on the outside place the window with the seal on it on the bottom edge with the interior flip started on the flange. Then, take one of the cord ends and pull it outward as the helper on the outside applies pressure where the cord is and it should zip the lip right on. Once the corner is reached pull the other cord end and zip the lip into the other corner. From there just keep going around the window frame. The guys in the assembly plants can put one in in seconds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
