Posted by usetabesteve on October 10, 2008 at 13:44:19 from (168.166.54.11):
In Reply to: Its always something posted by Lanse on October 10, 2008 at 13:31:40:
OK, think about this logically. That thing fell in there with a little hammering so it will come out one way or another.
Do you know someone that works at a muffler shop? They do that sort of thing all the time. The extraction would be a piece of cake with an acetylene cutting torch so long as you know how to direct the flame at the thinner steel and hit the oxygen trigger before the cast iron got too hot.
Can you compress that steel so it fits back through the hole that it went in? Try a pair of big screwdrivers, a small pry bar, or whatever you have.
Can you grab that with vice grip type pliers? If so, do that, tighten them up really tight and then pry on the pliers.
Lanse, this is one of those experiences that we all have. That "I was going to, but" is what makes you a lot more careful the second time you have to cut a muffler off an exhaust manifold.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.