Posted by Roy Suomi on October 11, 2008 at 21:01:48 from (76.189.182.37):
In Reply to: Hydralics schmatics posted by Osc27 on October 11, 2008 at 19:46:59:
What are you trying to accomplish ?? I can give you a quick run-down as to what constitutes a simple hydraulic system...First a reservoir with an outlet and return , A non pressured fill cap , and a suction filter of sorts[usually a screened covered cylindrical shape that screens the oil of large solids] to prevent large solids from tearing up a pump..Next is a pump..Larger fitting size is the suction side..Always use a hose thats marked suction hose..Hydraulic hoses used here are known to seperate the inner lining from the inner steel wire and cause suction flow problems..The smaller fitting is the pressure side out..Always use at least 2 wire hoses for pressure applications..Pumps come in different rotations[ clockwise or counterclockwise]..Next is the hydraulic line from the pump outlet to the control valve..The control valve should be marked inlet and outlet..Also the control valve should contain a system relief to protect the pump from overpressuring..Connect the other 2 or more lines to the individual functions..Then the return hose from the control valve to the reservoir..[I would install a return filter on the return line to the reservoir to filter out any impurities before they get dumped into the reservoir]..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.