Posted by Goose on October 13, 2008 at 07:24:53 from (65.208.249.179):
In Reply to: farmall H hydraulics posted by Kevin M 1976 on October 12, 2008 at 17:15:19:
Probably the cups in the lift cylinders. I've had to replace them a couple of times on my H.
I have an IH #33 hydraulic tilt loader on my H, and the last time I went to order cups, some young kid on the parts counter argued for ten minutes that there was no way an H could have a hydraulic tilt loader on it. About the time I offered to go home and get him a picture of it, an old timer on the parts counter cut in, looked through some old microfich, and in a couple of minutes had my loader on the screen. I had my cups two days later.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
