Posted by Farmerpete2400 on October 19, 2008 at 20:04:44 from (12.226.47.27):
In Reply to: 806 break leaking posted by MN Scott on October 19, 2008 at 19:43:39:
MN Scott said: (quoted from post at 19:43:39 10/19/08) You likly need to install a seal kit. Easy job. Pull the brake drum off and pull out the discs and seperater plate. Pull out the back plate with the piston in it. CAREFULLY pop the piston out with air pressure. Clean everything up and install the two new orings on the piston and reinstall it. Install the new pinon seal in the center of the rear plate, reset the auto adjusters and put it all back together. Bleed the air from the system and your done. If you need step by step details with pictures get yourself a I&T service manual for your tractor.
Thank You very much for explaining it to me. I will get a manual this week so I have something as a referance.
Thank You to everyone who posted above I relly appreciate it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
