Posted by jdemaris on October 23, 2008 at 05:55:08 from (67.142.130.25):
In Reply to: Metal Roof ? posted by Genos on October 22, 2008 at 20:30:24:
I wouldn't use anything but metal anymore, here in the northeast. One big plus is that it sheds snow so well. As soon as the sun hits it, the snow slides off - assuming you've got some pitch. If you don't, you shouldn't have metal anyway.
In regard to the 40 year guarantee? The roof can last virtually forever if you keep it painted/coated. Aslphalt won't no matter what you do. I've got several barns and one house here with metal roofs put on late 1880s and they are still fine. They are a little different since they have soldered seams. I've coated them once in the past 30 years. The only time I've seen any of the metal roofs actually fail - is when wind peels them off. That is usually caused by rotted wood underneath and bad fasteners, not the steel roof itself. One funny thing though. The building supply yard near me has half their red roofs with the paint already gone. Peeled right off like birch-bark. They are 15 years old. Not very good advertising for their roof products. In your case, I'd want it stripped - for several reasons. Here, three old roof coverings are the most allowed. In your case, you've got the old shingles, plus "nailers" that will have to be added that will run the width of the roof and probably spaced every 24". That adds some weight. Those nailers are necessary unless you've got very thick and hard roof sheathing at present - which I doubt. If plywood, older 5/8" is barely enough to trust to hold screws. And, if 1" boards, still barely enough if in perfect condition with no rot-spots. To be sure, the nailers are usually run sideways and they are fastened directly to the rafters.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
