Posted by Ultradog MN on October 23, 2008 at 19:47:29 from (65.103.0.3):
Even in the City... I've been working on rebuilding a disc. Had all the gangs off of it. Replaced a couple of bearings, fixed the disc scrapers and such. Got it all back together but didn't have enough horsepower to adequately tighten the big nuts on the gangs. There is a place that repairs big road trucks about a mile from my house. So I hooked the disc to the tractor and ran it on down there during working hours. I pulled just inside the door, dropped the dicc down and shut the tractor off. The mechanics all watched me come in but then got back to their work. The tire kid was the closest person so I asked him if there was someone who could use a big impact wrench and tighten down my gangs. He looked around a little confused and didn't see anyone offering advice. So he just shrugged and walked over to get the 1" impact wrench that they use for changing tires. Lucky for me the 1 1/2" socket that fits truck wheels also fit my disc. He managed to get one of the gangs snugged up before the whole bunch of mechanics gathered round to supervise. The kid tightened them all down good and snug. I thanked him, had a few $ in my shirt pocket and offered them. To the coffee fund if nothing else... They all just waved me off. My tractor isn't pretty or fancy or anything. But I know all those fellows were glad I stopped by. Just for the diversion. I know it didn't hurt the kid's reputation either. For knowing the right thing to do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.