|
Tractor Talk Discussion Board |
Re: Re: Re: Horse Power
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Aaron on March 23, 2000 at 09:50:33 from (129.186.165.125):
In Reply to: Re: Re: Horse Power posted by Swede on March 23, 2000 at 08:29:51:
If you work with your local dealer on parts and maybe a bit of shop advice, they would be glad to dyno it for you. If not, then find a dealer and they should be glad to do it for a fee. A dyno isn't something that the average tractor guy would have. It takes a lot of money and bit of skill to run one oand get correct readings. I agree with the post below. If everything you replace is stock, then expect stock power, if you get an 1/8" overbore, higher compression, ec, etc, then you might get 5 or at the most, 10 horse more than stock. As for how much you'll get vs. what you have now? All depends on how wore what you have now is. A dyno would be a great way to check that out. I've always wondered myself how much power you pick up. I've never noticed a power increase on the ones my dad has done. Just less blowby and a little smooter run.
Aaron
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
