Posted by Bob on November 03, 2008 at 17:06:55 from (69.178.228.68):
In Reply to: JD R shakes posted by tork rench on November 03, 2008 at 16:54:39:
The flywheel and the "clutch driving disc" inside the beltpulley are counterweighted, and if either is on wrong with respect to the crankshaft "throws", the engine will be out of balance and shake.
There are "matchmarks" on both parts, at either side of the engine, which should have been followed at assembly to keep the parts in proper alignment.
(DISCLAIMER: It's been a LONG time since I've messed with an "R". It seems to me that somewhere along the line there was a DEERE with the flywheel keyed rather than splined. If that is the case, it probably can't be put on wrong, but the clutch driving dics IS splined, and can be messed up, for sure.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
