Posted by Paul in MN on November 09, 2008 at 13:28:13 from (71.210.136.34):
In Reply to: John Deere 327 baler posted by HeyPigFarmer on November 09, 2008 at 12:52:56:
Hey..
My son and I bale about 20,000 bales per year. We bought the 327 when it was about 5 years old and have never regretted it. By now it has probably made over 300,000 bales and is still our main line machine. Ours has the #30 thrower that fills the cage wagons. We can get much fuller wagons with that thrower than the belt thrower on the similar NH machine. Sometimes when I am going to the field, I'll pull 2 wagons (empty) in tandem behind the baler. Just for entertainment a few times I've pulled the double wagons onto the field and set the range on the thrower to throw the bales in the second wagon. I doubt it will throw that far now, but it is a darn good baler. We do all our own repair work, so it has not been back to the dealer in the 18 or more years we've owned it. I don't think there is any such thing as a "no maintanence" baler. But this one has been pretty good.
About 10 years ago we had the chance to buy its bigger brother 328 baler. It is basically the same, but a wider pickup and a bit more capacity and about 7 years newer. It has been good too, but the #40 thrower has given more trouble with its thinner but higher strength steel. Stress cracks develop and then the throw arms break at the top. But we have done a few hundred thousand bales with this one too, and it has never gone back to the JD shop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
