Posted by Dave from MN on November 13, 2008 at 15:05:33 from (96.24.108.212):
I purchased a used OMC (Lorenze) 8" snowblower a while back at an auction. It is a 3 auger 2 stage. It is missing the outher PTO shaft. I thought I could just take the one off my manure spreader, but the square shaft is too small. Measuring the shaft on the blower, as far as I can measure I have it as a 1-3/16" shaft. Is this a standard size? If any one would happen to have the info for the exact shaft I need it would be great. There are no #"s on the blower to identify the model. I was wondering if a shaft off a forage chopper would be the right size. Any help would be appreciated cause I pretty much have to guess what I need. It is mounted on a 540 pto tractor so I am hoping that is what it is supposed to be. I just need to be able to get the last part to hook her up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
