Posted by NE IA on November 23, 2008 at 14:09:58 from (206.72.18.153):
In Reply to: Tire chain install? posted by Rusty machinist on November 23, 2008 at 09:25:21:
If the chains are a little to heavy you can do this. Lay them behind the tractor and take a chunk of wire and go around thru the rim, then drive forward. Be sure to avoid the valve stem.
What we have done at the fire station where we play sun today ice tomorow, like musical chairs sometimes. We came up with a very simple unit that takes over a half hour less time to chain up seven trucks. We take a 2 x 6 about 4 ft long and lay on the floor. This 2 x 6 has 2 x 4's, some have 2 x 6's, and the army truck I think has 2 x 8's nailed cross ways spaced so the chains lay down in between the cross boards.
We then lay the chains on the unit and let the cross bars drop down inbetween the cross lumber. Then we drive over them stopping dead center. Now we just have to wrap the chains up and over. If the sun comes out and we have to drop the chains we keep the home made unit in place under the tire so next time we chain up we don't have to start a single truck.
This also helps with not driving over the conector link and bending it. Very cheap to build with scrap lumber, and we have a unit for each chain. Dual wheels are a little tougher to build, but if you measure off the chains as they lay on the floor it is pretty easy.
I'm not good with descriptions, so I will say the unit looks like a ladder layed on the floor, only instead of the rungs sticking out, you have a recess to lay the cross bar in.
The first one I made we just layed out a 4 ft 2 x 8 with another 4 ft right on top. We then layed the chain on it and sprayed some cheap paint on each cross bar and then sawed and screwed the top chunks to the bottom 2 x 8.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
