Posted by bc on November 24, 2008 at 18:02:31 from (68.88.175.43):
In Reply to: IH 1466 Hydro problem posted by Walt7777777 on November 24, 2008 at 04:22:03:
Don't forget to clean the screen and replace the filter. The screen and filter partially blocking the flow will affect the output. You will hear some whine with it when that happens.
Unless you tore the gasket, bolt it back up. The pump housing isn't under pressure. It just hold the fluid in the cavity behind it. I change the filter on my 2606 a couple times and haven't replaced the gasket yet on that plate and no leakee.
I'd look for something or some sludge holding a check ball or relief valve open. Anywhere you see a thin bolt head as Owen said. Not all have the psi stamped on them or else they are painted so you can't see it.
Flow test the pump with a clean 5 gal bucket. Mark at 1 gal intervals. Take a line loose and time how long it takes to pump a gal or two. Then replace the fluid. As pumps decline so does the gallons per minute it puts out.
If your pump runs more than one system, then you need to isolate them to find what is wrong. Not as likely, but a leaking piston seal on a cylinder will allow flow by and loss of psi so check all your cylinders.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.