Posted by Lynn Shroyer on November 30, 2008 at 08:22:59 from (67.142.161.32):
In Reply to: Re: 570 case tractor posted by John B. on November 26, 2008 at 15:59:14:
I ws running a grain auger it started to slow down like the motor came under a heavy load. I shut the auger off then but didnt help. I shut off the engineand after about a minute I tried cranking the engine wouldn"t even try to turn over couldn"t crank engine for nothing so we thought it was locked up started to tear the engine down took the oil pan off thought there might be metal shavings nothing took the head off nothing out of the ordinary we tried turning the engine over with the 1/2 drive nut in the front of the engine I bet it took about 50 to 75 ft lbs. of torq to rotate it. I didnt know if that was because the transmission or if the hydraulic pump has anything to do with it. The inside of the cylinders walls look unbelievable oil pan was very clean also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
