I think it was through a FarmShow article that I located a similar job done in Sheyboygan Falls, WI. Had noticed that many good repowers were done with 855s. Went to see the tractor, found his machinist who made the adapter plate, and he made one for me. That was something over $700 with heat treating- which is needed to relieve stress of drilling all the holes in the steel. Found a couple 855s on a neighbor's auction, had the best one rebuilt. Everything was rebuilt except the air compressor- mistake. Those bearings went bad after 4 days, took out the engine mains (common oil supply). Left the pump in because neighbor said he had an air-ride seat for me. Removed the pump, put in different accessory drive and remounted injector pump. Had to add a governor, front sump oil pan, extended the side frames with half-inch plate, heavy- half or 3/4 angle for the front mount. Put in a bigger radiator, although it now has the original back in. Custom made hood to cover the extended length. This was done in the mid- 90s, spent a few thousand on it. I still have oodles of notes, addresses, pix, etc. Machinist was Lee Sixel, in the Sheyboygan area. Actually never met him- did it all over the phone. email is open.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
