Its Foundation Grade treated lumber that's kiln dried after treatment. I decked a trailer about 5 years ago with 2x6 and 2x8 covering 16'. Crosswise planks. They are HEAVY, but so far there are NO cracks opened up from the wood drying. One plank has warped about a half inch in the middle of the span between frame rails. I clamped each plank tight against its neighbor and used the trailer deck screws that I bought from McMaster-Carr that are now more available than they were those years ago. I've not tried to remove any. I expect many won't come out easily since I've used the trailer to haul a tank of 32% liquid N fertilizer and it has spilled when the vendor over filled that tank. Running only 325 gallons through a 6" diameter hose makes it hard to shut off precisely. That's nearly 3600 pounds of fertilizer, on a couple axles, it works fine. Spills have been hosed off, but the countersunk screw heads probably didn't get cleaned. With the empty plastic tank in place, the trailer weighs right at 2000 pounds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.