Posted by paul on December 04, 2008 at 00:16:35 from (66.44.132.73):
In Reply to: Worst breakdown posted by 37chief on December 03, 2008 at 22:52:37:
I was combining oats with the Gleaner F - gas.
Just was running a little rough, drove to the yard & cleaned out the radiator, looked it over, worked on the points, didn't really see anything. Ran better.
Went back to the field, combined 1/4 of a round, it ran really rough. Pushed in the clutch.
BANG. Very loud bang.
Then everything was quiet, except the combine cylinder spinning down to a stop below me.
I smiled at myself, & turned the key - nope, didn't do anything. Didn't expect it to.
Climbed down to the ground, went back to the engine, and could see smoke coming out of the hole in the oil pan....
Mechanic thought he could save the engine. Dropped the oil pan, & bits & pieces fell out. Piston flakes, a valve or 2, rings, couple pieces of the camshaft (it boke at every bearing...) He still figured he could rebuild it, but then found an oil journal that was smashed, then it wasn't worth messing with.
Figure a main bearing turned & starved one side of the 6 cylinder of oil. The rod broke & stopped the engine in a couple revolutions at most, with the end of the rod shattering the camshaft & smacking the oil journal.
It was a lonely walk back to the house.
Had to drop the header where it sat, and towed it back to the yard backwards. Mecanic was kinda busy, so we pulled the engine off the top & drove it over to him.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.