I agree, and is why I posted here, one thing I appreciate is the fact that no one here is shy about laying it out as they see it, on the table in front of all, this neutral/ground arrangement is important, and needs to be done right, as well all other aspects, electricity is nothing to fool with.
I had to run an extension cord to a surge protector, to get powered up directly off the generator, getting online was strange, this old dial up line gets 56,667 bps, and still does an ok job for internet access, cable was out, but the analog line kept fading and my ISP kept timing out, until finally the line stabilized or something.
I also agree, better to bite the bullet and do a job right, this farmer fix scenario is now going to result into a dedicated stand alone back up generator to feed both 200 amp panels, large enough to cover the total overall loads + whatever you need over that, so the continous rating covers all start up requirements etc. Time to spend some money, getting some numbers for it hired out and installed vs. buying direct, and having an electrician wire it up, and the latter is usually the most cost effective way.
In the interim, all aspects considered, I had to give this some serious consideration, it's all I have at the moment, by the same token, overloading or creating unsafe conditions take first priority, if it can't be done, so be it, I'll get through this some how.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
