Posted by RUNnWILD7810 on December 14, 2008 at 20:07:56 from (64.12.117.74):
In Reply to: OT: Maaco?? posted by Casey in Ky on December 14, 2008 at 13:31:58:
I had a truck painted at one in N KY. I upgraded to the best paint job they had posted on their wall. I talked to the sales guy. I made a list of the scope of work to be done to the truck so we were all on the same page. We both signed off on it prior to the start of work. I thought this would be a good way to make sure it gets fixed the way I wanted it and what i was paying for. I did not want to have to depend on a verbal agreement.
To say the least they are a bunch of hacks. There was some rust to be fixed in the cab corner. The sales guy said they would cut it out and weld in new metal. I was cahrged for this too. Two weeks later they called to say it was finished. I went to pick it up 1/2 a mile a way it looked decent. Up close it was a disaster. Over spray everywhere. The cab corner looked rough. I reached up under the cab corner to feel how the metal was welded in. They never cut anything out they. All I could feel was cardboard and bondo that they used to fix the rusted out area. I was pissed to say the least. I would never go back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.