Tractor Talk Discussion Board |
Re: Re: Wilson Tire in Marengo Ohio
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by JD4boltB on April 10, 2000 at 17:55:43 from (152.163.201.213):
In Reply to: Re: Wilson Tire in Marengo Ohio posted by Bishop's Red Barn Delton Michigan on April 09, 2000 at 18:15:14:
i did make a mistake and did not thoroughly inspect the wheels upon delivery. i trusted the wilson's not to screw me and figured i was getting G steel with no cracks and welds, unrepaired. however, this does not make a difference seeing the wheels were not as represented. they have been repaired because they were cracked. period. as for my buyer's remorse, the remorse i am having is not getting what i thought i was paying for. all wilson's had to do was say 2 spokes had been repaired, one on each wheel. then i could have decided at that point if $1900 was too much for them. i would know that my expenses would be $1900 plus an unknown figure, plus $150 to sandblast, prime, and paint. that unknown figure in the middle gets you every time. and seeing what i have invested in tractors and parts so far, $1900 is a drop in the bucket. it's the nickel and dime stuff afterwards, somewhere to the tune of $400, that one must pay to put something they bought into the condition it was supposed to be in the day it arrived here that'll kill ya. i guess you don't care what you get or pay as long as someone sends you something that closely resembles the item you ordered. thanks for responding too so i know i should steer clear of your 'business' too. i know the slogan says "the customer is always right"... truer words have never been spoken.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|