Posted by Steven f/AZ on December 17, 2008 at 12:45:37 from (216.67.213.217):
In Reply to: Quart of oil posted by richard from se az on December 17, 2008 at 07:27:05:
My Mobil 1 full synthetic is still $5 per quart when bought in the 5 quart jugs.
I will NEVER go to a quick lube place, EVER. They have messed up vehicles for years, put the wrong oil in, swindled people out of money, etc.
I will not go to the dealer either. I got shafted once there too. Pickup wouldn't run right, carb problems - variable venturi Ford. Service manager said it's a good carb, except when it's cold or dusty (when is it not cold or dusty in ND?). Said it would cost $500 to replace with something better. Didn't have that kind of cash so I said rebuild it. Cost $490 to rebuild!
Had a "reputable" shop flush a transmission for me once. Had a hole in the tranny cooler and got coolant in the trans. Asked if it would fully flush out the trans... "yes sir." Still didn't shift right afterwards, so I pulled the pan and found... coolant, lots of coolant. That was a $99 shafting.
No more, never again. I buy the tools I need to do the repairs for less than what a labor charge would be and do the work myself. I don't know if I'll even buy another vehicle from a dealer due to the mistreatment I've received from more than a few dealers as well. Private party purchase will work fine for me, you're not any safer buying a used vehicle from a dealer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
