Posted by MarkB_MI on December 23, 2008 at 02:09:55 from (216.234.123.188):
In Reply to: Re: broken bolt posted by Roy in georgia on December 22, 2008 at 16:51:02:
Roy, I know it sounds counter-intuitive, but that bolt MUST be hot to come out. You need to break the bond between the bolt and head, otherwise if you do screw the bolt out you're going to bring the aluminum threads along with it. Due to the dissimilar metals, there's corrosion in the threads and you need heat to break it down.
You will never get it hot enough by heating the head. Not only does aluminum have a low melting point, but it's highly conductive and will just sink all the heat away from the bolt.
Yes, you could damage something by getting the bolt too hot. But you WILL wreck your head if you don't.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
