Ours was coal fired. It had a box about 15 inches square, and 18 inchs deep that was the fire box. It had a removable for cleaning, grate about 3" off the bottom, made from iron rods about 5/8 diameter, spaced abput 3/4" apart. A 3" diameter inlet pipe was J shaped and about 10 inches taller than the top of the box. The "chimney" was 6" and ran for about 3 feet under water to heat additional water with flue heat before turning up to the vertical, and stood 5 or 6' above the box, and was on the opposite side from the intake. All these were iron/steel and sealed to prevent water from getting in. The lid was hinged to allow loading and tending, but was overhanging to limit cattle from splashing water into the joint. A damper was set into the exhaust pipe to regulate draft. I would put it into both intake and exhaust to regulate combustion more easily. Both had cone shaped "hats to keep out rain. It was set into the tank with about 2 inches of wall above waterline. This is a memory from more than50 years, so take it for that!! JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
