Maxgussam said: (quoted from post at 03:13:21 12/29/08)
Not a Guage said: (quoted from post at 14:25:07 12/28/08) The 410 is not a guage it is a caliber .410 and is therefore .410 inches in diameter. The guage of a shotgun is determined by the number of balls of lead the diameter of the barrel which equal one pound of lead. There are also very large shotguns the largest I have heard of is 4 guage they are usually mounted and not hand held.
Are these 4 ga also known as "Punt Guns"? I saw one such gun fired on a Discovery Channel show...It was practically a crew served weapon.
Quite a few 4bore guns still in use for wildfowling in UK. 6bore not quite so common, but lots & lots of 8bores still around. People reload commercial boiler cleaning 8bore cartridges, since I think only one company still produce 8bore cartridges.
10bores becoming more common since the nonsense about not using lead shot. Since steel is so poor in normal loads, the 10bore has made a bit of a come back here.
Some 4 bores were made to double as punt guns (6 bores too) but most were shoulder fired.
Punt guns tend to be 2bore up to about 1 1/2" diameter barrels, all new ones are made by engineer enthusiasts, but I bet the cost per shot of 6 or 12oz of tungsten or Hevishot tends to concentrate the mind a bit!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
