Dude, it's a great way for removing rust. I have been doing it since 2000. Have done most every part on 4 Allis's this way. You have to love any system that will allow you to remove a nut this rusted for 70 years on a plow, and screw it off with pliers after cleaning
If you have a decent charger (manual style, not an automatic), forget the battery.I've used them in the circut before, just not worth the effort.
Washing soda does produce a small amount of hydrogen, still not something to do indoors.
Temp does speed things up a bit, but here in Georgia, I have parts going most all year long. I do most of mine in either my 250 gallon tank, or in a plastic 55 gallon drum, but any plastic container will work. I've used kiddie wading pools to do rear wheels, and used four picnic table benches in a square, linded with plastic to do a huge fender. I don't drain them unless it plans to stay below freezing for several days and nights. Even if a little bit of ice happens, it doesn't hurt anything. If you use a trash can just remember they get very unsturdy with a good load of water in them and may split. 8 lbs to the gallon is a load for cheap plastic! Your best speed comes from good commections, 8-10 amps or so of power, and lots of surface area of anode (I use old bush hog blades) *** most important is positive to anode, ground to your part*** do it backwards and your part goes away! (ask how I know that!)
here's some good reading too, sorry to get so long winded, but yell if you need help! here's some reading when you don't have anything to do-
All do the same, but each has some different twist.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.