Posted by RodInNS on January 02, 2009 at 14:36:08 from (216.118.158.123):
In Reply to: Re: Jinma tractors posted by dhermesc on January 02, 2009 at 11:59:10:
I noticed that too....
I also noticed that the ones that do have them don't seem to work them too hard, or don't know what hard work is.
I'm not familiar with the Jinma specifically, but the one china tractor line that I looked at around here (TaskMaster) wasn't much to speak about. The fit was pretty rough on them. Castings looked to be of rather dubious quality and the basic technology of them appeared to be stuck somewhere along the same lines as IH was in the 50's. So... if you want to buy 50 year old technology and it's related problems then mabey the china tractor will be OK. If that does the job, that's fine.. but there's a world of difference in features between those tractors and the offerings from NH/Deere/Kubota and others. The little jap tractors do tend to be pretty good at this point too although they are light and can be broken under a loader.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
