Posted by buicanddeere on January 09, 2009 at 07:52:38 from (216.183.153.49):
In Reply to: Re: math question posted by Jack a on January 09, 2009 at 07:18:08:
True the taller wheels would work but.......The center of gravity will be raised. 1st gear and reverse already plenty quick at 2-1/2 and 3.0mph are going to get faster. More difficult to control on and off trailers etc. Brakes will be less effective. Higher to step up onto and off the seat. Hard to say what the valve train condition is. Most rebuilders never test valve spring pressure or measure lobe/lifter wear. A set of springs and fresh ground cam/lifters are very economical. And eliminate a lot of mysteries of why a fresh engine doesn't run smooth or make decent power. I wonder if there was an option for electrics on those C's. Lights while on the road or putting around are handy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
