My standard racks are 7-1/2 x 15. I stacked 4 tiers per load. I stacked 5 bales in each layer, 4 to 5 layers high, with a cap of four bales. 15' long gives you a little place to stand to finish the last tier of bales. Can also stack a few single bales in front of the last tier. This would give 96 bales per load minimum, more if you went 5 high plus the cap. A cap of four bales per tier helps lock the load together. 8' wide would be a little better than my old 7-1/2'. A 1x2 strip around the edge of the rack helps hold the bales in place too. All depends on how you like to stack it. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.