Tractor Talk Discussion Board |
Re: Farmall M Tractor Losing power
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by ltf in nc on April 24, 2000 at 09:03:39 from (206.228.214.138):
In Reply to: Farmall M Tractor Losing power posted by Chris on April 24, 2000 at 08:40:56:
Chris, Are you stating that you must get the rpm's up to 1500-2000 before the alternator starts to charge? If this is the case you need not change the pulley size. Instead you need to get the excitation voltage fed to the alternator correctly. I will e mail a schematic to you. As for the tractor not making power, I think you are starving the engine for fuel. Take the plug from the bottom of the carb and let fuel drain and observe the amount being delivered. It should be a steady continuous stream about 1/8 plus in diameter. Anything less will bog the engine down when working hard while letting it idle just fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|