1st thing, the uhh accidental discharge, not good, 2nd, most of these type of rounds have the potential to penetrate things like you describe, some would punch clean through a home and it's contents. I can say that .308 military ball ammo will punch right through an old chevy tire rim at 200+ yards, punches it like a machine, same with '06 ball ammo, neck that bullet down to a .270, similar shape case and powder, and use a bullet that does not expand, or break up, you would be surprised at what a caliber like this can penetrate.
He needs to really check himself on that accidental discharge, we had a new hunter/friend do something like that, just to see if his shotgun was loaded, we were in a blind, he pulled the trigger, boom, nothing to shoot at, muzzle was not where it should have been, he was just seeing if it was loaded..... then he just about took the butt of one our stocks to the side of the head, in my book there ain't no excuse for any of this when it comes to firearms, CLEAR THAT WEAPON !!!!!!!!!! & follow safe protocol at all times, you will be safe, slack up and yeah you'll be doing unwanted penetration tests with the potential of serious injury or death.
See the link below, this guy could have bought it if he was 1" further to the left. I think the target was obviously something hard, not good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
