Posted by Clefus on January 27, 2009 at 16:56:04 from (98.21.25.52):
In Reply to: 27V Sickle bar mower posted by mdiem on January 26, 2009 at 15:58:56:
I have one I restored....bought it for $125...another couple hundred in new sections, ledger plates,pitman bearing,paint ect...works good...made a bracket to put a cylinder on to lift....this was before I bought a haybine...now it just sets around...would like to hook it up this summer and try it more...maybe on second cut...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
