deereman34 said: (quoted from post at 19:16:58 02/06/09) I have an older model troy bilt horse tiller with a 7 horse kohler motor on it. I am needing a new starter assembly...im not sure what you call it, but its the part the you pull to crank it. It has wore out and the place where I have my work done wasnt able to find me a new one. Any help? Thanks
i am think'n mine had a 6HP will have to look for the old engine to confirm,,, starter was good in fact I never used it but a few times and that was when it would not start after it set up for awhile,,, The engine blew up so I got a new engine B/S delivered to my door for $175 with electric start,,, it has more power than the original,,, the replacement may B a 5HP will try and post a link
Here's the link but I see the one I got cheap is no longer available,,, they got wet and had some rust,,, none that i could c that hurt the engine
So if a new starter looks to b rite pricey a new engine mite B the way to go,,, I did buy another horse model that did not have the electric start and had points,,, the electric starter are flywheel would not interchange,,, blocks different :cry:
If you don't know you can down load the operators manual off the net,,, its over 100 pages i think,,, nice to have and mite have the parts break down[/url]
BTW I was very pleased with small engine warehouse
This post was edited by Hobo,NC at 13:36:23 02/06/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.