|
Tractor Talk Discussion Board |
Re: Re: Ford 3000
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Napa Joe on June 03, 2000 at 16:40:09 from (63.27.239.250):
In Reply to: Re: Ford 3000 posted by Karl O on May 31, 2000 at 15:43:28:
I had the same problem with my D-14 allis took the bowl off and cleaned it out, opened the shut off valve below tank it looked like enough gas was flowing to bowl, everything else from bowl to carb ok so I took the line off between bowl and shut off there was gas flowing but what I found out was not enough gas, took the shut off valve off tractor and found it was half filled with gunk cleaned it out and found out just how fast gas does come to bowl.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
