I'm still working on this Belarus 825 Starting problem.
The 825 still will not start and I'm hoping someone can give me a clue on what to do next.
This tractor was running in the Fall. I found that the relay had blown a fuse. I replaced and cleaned everything up (Battery terminal, copper connections, ground switch connections, etc.) and tried it. The voltage at the Old selonoid was 12V and jumped to 24V when the ignition switch is turned. Since there was absolutely no action or sound or any attempt to engage the starter I figured the selonoid needed to be replaced. So I ordered a new one.
I installed and tried - Same thing. Next, I load tested the batteries and found that the left battery (as you sit in the driver's seat) did not hold the load. I replaced that. Made sure both batteries were fully charged and tried.
There was 28 - 29 Volts at the selonoid but still absolutely not a click or any attempt to engage. One guy at the auto parts suggested "it's going directly to ground" but didn't elaborate.
I'm beginning to think I may have it wired incorrectly at the relay although I was careful to replace that with the original configuration.
Is there anything anyone can suggest? I've been working on this allllll winter.
As for the relay wiring, there are 4 connections on the right and 3 on the left as you look down from the seat facing the rear window.
Here's my layout:
Left closest to seat: Negative Battery terminal from right battery (facing rear window) Left Small middle terminal : Green Left Fuse terminal : Lavender
Right closest to seat: To Positive left (facing rear window) battery terminal Right combo connection: Orange Right Small standalone terminal: Red Right Fused Terminal: White
The relay clicks and, as I mentioned, there is 24V at the selonoid. I measure accross the two large selonoid connectors and get 24V (28 Actual) when key is turned. I also get 24V from small terminal on selonoid and ground when key is turned.
Anything you can suggest would be GREATLY appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
