Posted by Bill(Wis) on February 10, 2009 at 14:27:56 from (70.15.163.124):
In Reply to: Corn Planter Advice?? posted by New England Farmer on February 10, 2009 at 12:04:17:
There are tons and tons of two row planters to be had. Most are approx 40-50 years old. Most have 38" row spacing. Assuming that's not an issue (30" rows are now pretty much the standard) then look into the condition of the planter. If it has a fertilizer attachment it will most likely be rusted. If you look long enough and hard enpogh, you might find one with the original paint on it and very little wear sitting in a shed somewhere. If you have a pickup truck you can haul it home. Three point or not is not terribly important as the pull behinds work well. Limiting factor with an 8N will be the weight if you insist on three point. An N will support 500-600 lbs but not much more. Any more than that will require weights on the front of the tractor and even then I doubt that that little tiny hydraulic system will lift more that about 800 lbs on those skinny little Cat 1(-) lift arms. The better made and designed planters were JD and IH but there were others as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
