Posted by MarkB_MI on February 16, 2009 at 18:18:47 from (66.103.227.167):
In Reply to: Penetrating Oil posted by Tom 43 on February 16, 2009 at 14:15:17:
I believe that penetrating oil has its place, but I've never seen it work the magic that some folks ascribe to it. Certainly, if you have an exposed, rusty thread (an exhaust manifold stud, for example), any lubrication helps. But for a fastener with no exposed threads, I have a hard time seeing how penetrating oil is supposed to soak into the threads.
I crack up when I read suggestions to use penetrating oil to loosen spark plugs, drain plugs, or my favorite, pipe plugs. How is oil supposed to get past a gasket or interference fit that is capable of holding oil or air under considerable pressure?
I know what works: Heat works. Get an acetylene torch and try it. You will be amazed. Use a brazing tip for small fasteners, and a cutting tip for the big stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.