|
Tractor Talk Discussion Board |
USING A HYDRAULIC MOTOR FOR A PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on June 15, 2000 at 19:19:37 from (172.147.72.67):
Anyone ever use a hydraulic motor to power the PTO on a tractor? I have a tractor with about 20 GPM flow and about 2000 PSI. I've been thinking of installing a hydraulic motor in the differential with the shaft sticking out through the cover where a PTO shaft normally is installed. I checked with a local parts supply and I can get a 1" diameter with 1/4" keyway female to 1-3/8" OD X 6 spline male adaptor for less than $25. I have a valve and can find a hydraulic motor with the torque and RPM @ 16 GPM to meet the need for about $180. It seems to be a reasonable way to go since I have the available hydraulics on the trator. Opinions, Please. Ken McWilliams
Dayton, OH
Follow Ups:
Home
| Forums
Today's Featured Article -
On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
