Posted by trucker40 on March 01, 2009 at 07:43:22 from (69.150.232.136):
In Reply to: Another Allis Attempt posted by Lanse on February 28, 2009 at 18:05:07:
I think you are off on the timing.If you have it on the compression stroke,and the piston is at top dead center,the rotor should be real close to if not right on the number one spark plug lug on the mag or distributor.Set it on TDC,mark the position of the number one plug wire on the mag or distributor.Pull the cap off and it should be pointing to your mark,or just a little past.Once you get it like that,and you are positive its on the compression stroke,which means both valves are closed,then it should hit by cranking it if you have clean dry plugs,are getting good fire to them,and we know you are getting gas.Then it should run.Even if the timing is off a little it should run when you pull it.So you might be off just a tooth on the gear that turns the mag,(plus if you turn it the wrong way remember to turn it 2 teeth teeth back to change it)or maybe dont have it turned enough,or you could have the plug wires in the wrong place.If you cross 2 wires it probably wont run,but it would hit and try maybe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
