|
Tractor Talk Discussion Board |
Re: Good bellymower tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve Warfle on July 06, 2000 at 06:11:56 from (205.232.79.56):
In Reply to: Good bellymower tractor? posted by Drawbar on July 05, 2000 at 13:00:43:
I was in your exact position a year and a half ago. While the AC B and the Farmall A are nice machines, you'd be much better off with a Ford N series. They have a three point hitch that will lift a big implement, are low to the ground (safer on hills), easy to drive. Plus they're popularity makes almost every part easily available rather cheaply. Just go tyo Central Tractor, and look at the number of parts availabe. I grew up loving AC's, but I had to admit, from a utility point of view, that 2N is a way better tractor for my needs. I have a neighbor with a AC b with a three point hitch conversion, and it won't even lift a mower. As for live hydraulics or PTO, it would probably bump you up to a higher price, although an AC CA gives you sort of live PTO, with a hand clutch, and these are in your price range. That's about the only vintage tractor that I might think about. As for rototilling and snow blowing, these old tractors just weren't designed with slow enough gearing to make that practical. I use a back blade on my 2N, and it works great. Newer tractors with hydrostatic tranny's allow you to creep slowly at high RPM's. I have a 5' brush Hog, a 6" finish mower (rear three point hitch mount), a 6 foot back blade, a three point hitch rear scoop (handiest thing...throw that wheel barrow away...saves your back. My wife always has me mulching, moving rocks, etc....very handy). I looked into getting a belly mount mower, but you sort of need a dedicated tractor for that, because mounting it is difficult, and then the three point hitch is tied up lifting the mower through a pulley arangemnt. It turns out with a 6 foot mower, my 2N works as a great mowing machine. I wouldn't switch to a belly mount after learning to "waggle" that mower under fences, etc......I go arount the yard once and then my wife takes over. Good Luck
Steve Warfle
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
