Posted by Iowa_tire_guy on March 07, 2009 at 17:29:29 from (207.177.88.101):
In Reply to: Fixing a Bent Loader posted by Clodbuster on March 07, 2009 at 16:58:24:
I had a flatbed aluminum semi trailer once that had been sprung. I took it to a trailer shop and the guy had I-beams set in the concrete floor of his shop. He just chained the trailer down where he wanted it to stay and put 20 ton bottle jacks under where he wanted it to move and went to work. After he had it past where straight was, he let it sit in the twist all night. Came out pretty good, of course he had down it many times before. You might be able to rig up a way to do the same thing with jacks and untwist it.
And by the way would you be interested in the brackets that go from the tractor axle to the frame for that loader?
This post was edited by Iowa_tire_guy at 17:30:59 03/07/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.