Posted by JML755 on March 09, 2009 at 13:17:46 from (66.184.63.110):
In Reply to: Apology to Al Gore posted by cj in wisconsin on March 09, 2009 at 06:02:09:
jerrycentmi said: (quoted from post at 10:52:35 03/09/09) An article in our paper (Grand Rapids Press) yesterday was about a local benifactor that donated a windmill to a local church. The tec. for the company that sold and installed it was excided to watch it spinning away. His words was that it cost beteen $10,000.00 and $12.000.00 and would save the church $200.00 a year. Gosh,,, A 50 year payoff if it never needed maintance.
Supervisor of Harrison Twp, MI (east side of state) wants to put up windmills on the shores of Lake St. Clair. I've been on the lake on more calm days than windy days. Jenny (the Gov) and gang are counting on Wind Power to save Michigan's economy. Just goes to show what kind of brain trusts are running the state. There are places where windmills MIGHT get a return on investment. I don't think Michigan is one of them. They should be focusing on getting us weaned off oil for our cars (electric or hydrogen fuel cell) and build nuclear power plants to provide the additional electric power to do it. Sounds simple but they'd run into a few tree-huggers and NIMBYs that will protest and nix the deals and the politicians of today don't have the kohoneys to stand up to them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
