You want one for a Category II 3ph. They save an awful lot of time and frustration. On your implements you will need to add the sleeves, over the mounting pins. A hydraulic top link makes them even handier. I"ve had two of them for over thirty years, one modified a bit to fit the 4450 Cat III, but still works for II, like the other one. Use them on 20, 30 40, 50 series. Another mod- they snag hydraulic hoses on turns with pull type equipment. I drop in a one inch pipe, with washers welded on the ends, and lay the hoses on the pipe- they don"t snag on the latches then.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.