Posted by rettchr2 on March 14, 2009 at 10:41:44 from (66.175.203.54):
In Reply to: WPA posted by frdmnn on March 13, 2009 at 17:15:02:
While outside this morning shoveling horse manure, I got to thinking about some of the cheap shots leveled here at the WPA, CC, and by implication—some of the current stimulus activity. It occurred to me that the people making estimates like “half hour to grease a wheelbarrow wheel” or extensive time leaning on a shovel are not likely to have been too close to the handle of either a shovel or a wheelbarrow. I was born in 1941 so I have no direct knowledge of either WPA or CCC. However, my father had a job in the 1930’s on a WPA project. This job was in a limestone quarry where rock was being crushed and then hauled/spread to make all weather road surfaces in their township in western Wisconsin. Although this seems like a worthwhile project, it also does not sound like a cushy job. As the depression had hit agriculture well before 1929, the opportunity to earn any cash money was much appreciated by him. Any “cure” to a serious problem is likely to have some undesirable side effects. Go and read the side of your pill bottles or the flyer that comes with a prescription. Rush, and the cadre backing him for sainthood, seem to comprehend about half of “loyal opposition”. It is not enough to just say what will not work. Improvements and or better alternatives need to be proposed. WPA and CCC certainly had shortcomings and inefficiencies, but I think that they were a lot better than an alternative such as doing nothing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
