Posted by Bob Huntress on March 19, 2009 at 16:51:40 from (74.250.7.10):
In Reply to: allis hydraulics posted by randy47 on March 19, 2009 at 16:25:32:
Yes you can, but not likely with the valve manifold provided. You will need a two position valve to shift between the two pumps. It is also possible to simple add a valve that is not part of the manifold, but this would have to a three port, two position valve. It would require a pump discharge from both pumps and one port directing flow to the valve manifold(Block).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.