all the noise related problems we've ever had at work have always been traced back to the neutral side. not enough capacity usually due to shared neutrals, also separate circuits when sharing long runs of 10' or more of conduit for ex. can amplify odd harmonics & they ride along the top of the sine wave just like ripple controllers work for off-peak. sometimes running more juice through the wire makes it worse & smetimes it saturates the neutral enough that the noise cancels out or has a hard time building amplitude. other times it makes it worse, similar to a poor ground in a DC circuit. a noisy ballast could possibly be eliminated as the source also. solid-state digital ballasts help too. good luck im no expert.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.